Ga door naar hoofdinhoud

Wijzigingen in stap #6

Bewerken voor David Sylvester

Bewerking goedgekeurd door David Sylvester

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* yellow] Remove the two 15 mm Phillips #0 screws holding the DLP heat sink to the light engine board.
[* icon_caution] Springs underneath the screws help hold the heat sink on top of the DLP chip. During reassembly do not tighten the screws down all the way. Doing so can damage the DLP chip.
[* yellow] Remove the two 15 mm Phillips #0 screws holding the DLP heat sink to the light engine board.
[* icon_caution] Springs underneath the screws help hold the heat sink on top of the DLP chip. During reassembly do not tighten the screws down all the way. Doing so can damage the DLP chip.