Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Wijzigingen aan stap #6

Bewerking door Arthur Shi

Bewerking goedgekeurd door Arthur Shi

Voor
Na
Ongewijzigd

Stap regels

[* black] Reattach all brackets and posts from the old hard drive onto the new enclosure.
[* black] Reattach the iMac's wide SATA data cable to the new temperature-capable SATA cable. Route it out of the way.
[* black] Reattach the iMac's SATA power cable to the SSD enclosure.
[* black] Trace the two-wire temperature cable you disconnected from the old hard drive. It should end at a socket on the motherboard.
[* black] Note which side of the socket connects to the black wire.
[* black] Disconnect and remove the old temperature cable. You will no longer need it.
[* black] Connect the two-wire red-black temperature cable to the same motherboard connector, matching black wire sides. Route the cable out of the way.
[* icon_reminder] Continue to follow the instructions in the hard drive guide to re-assemble your iMac.

Afbeelding 1

Geen vorige afbeelding

Toegevoegd