Wijzigingen aan stap #10
Bewerken voor Jeff G —
Bewerking geweigerd door Adam O'Camb
- Voor
- Na
- Ongewijzigd
Stap regels
[* black] Remove the following screws securing the logic board to the rear case: | |
[* red] Two 2.3 mm Phillips screws | |
[* orange] Two 2.7 mm standoff screws. | |
[* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver. | |
[* yellow] One non-magnetic 2.7 mm standoff screw | |
[* icon_note] Be sure to put this screw back in its original position at the top of the logic board. A magnetized screw may interfere with the digital compass. | |
[* icon_reminder] Reassembly hint: when putting the standoffs back in, use the tip of a spudger like a screwdriver to get them started. | |
+ | [* icon_caution] If the tip of the spudger breaks-off inside of the standoff screw, remove the screw from the phone and in a well ventilated area carefully expose the standoff screw alone to high heat. This will burn-away the plastic spudger tip from the internal threads. Keep all heat sources well away from the rest of the phone at all times. |