Ga door naar hoofdinhoud

Wijzigingen aan stap #10

Bewerken voor irvbrom

Bewerking goedgekeurd door Andrew Optimus Goldheart

Voor
Na
Ongewijzigd

Stap regels

[* black] Remove the following screws securing the logic board to the rear case:
[* red] Two 2.3 mm Phillips screws
- [* orange] Three 2.7 mm standoff screws
+ [* orange] Three 2.7 mm standoff screws (note that only the top standoff screw is non-magnetic and must be re-installed in that position)
[* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver.
[* icon_reminder] Reassembly hint: when putting the standoffs back in, use the tip of a spudger like a screwdriver to get them started.