Ga door naar hoofdinhoud

Wijzigingen aan stap #10

Bewerking door Dominik Schnabelrauch

Bewerking goedgekeurd door Dominik Schnabelrauch

Voor
Na
Ongewijzigd

Stap regels

[* black] Remove the following screws securing the logic board to the rear case:
[* red] Two 2.3 mm Phillips screws
[* orange] Two 2.7 mm standoff screws
- [* icon_note] Standoff screws are best removed with a [product|IF145-388-5|standoff screwdriver|new_window=true] or [product|IF145-343|standoff driver bit]. A small flathead screwdriver can also do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
+ [* icon_note] Standoff screws are best removed using an [product|IF145-343|new_window=true] and [product|IF145-326|driver handle|new_window=true].
+ [* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
[* yellow] One non-magnetic 2.7 mm standoff screw
[* icon_note] Be sure to put this screw back in its original position at the top of the logic board. A magnetized screw may interfere with the digital compass.