Ga door naar hoofdinhoud

Wijzigingen in stap #17

Bewerken voor johnsawyercjs

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Remove the following 13 screws securing the logic board to the rear case:
[* red] Six 7.2 mm coarse-thread T10 Torx.
[* orange] Two 6.8 mm T8 Torx. When reinstalling these two screws, don't overtighten them, as the plastic tabs they hold down are thin and brittle, and can crack.
[* orange] Two 6.8 mm T8 Torx. When reinstalling these two screws, don't overtighten them, as the plastic tabs they hold down are thin and brittle, and can crack.
[* yellow] Three 7 mm fine-thread T10 Torx.
[* green] Two 24 mm T10 Torx.