Ga door naar hoofdinhoud

Wijzigingen in Turnigy 9X Mode 1 to Mode 2 conversion introductie

Bewerking door Nick

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd
Introduction
The Turnigy 9X is an inexpensive and highly hackable transmitter for remote controlled aircraft. This guide will show how to change a Turnigy 9X from Mode 1 (with the throttle on the right and elevator on the left) to Mode 2 (with the throttle on the left and the elevator on the right). [ … ] Thanks to Miro at iFixit for photographing this guide while I performed the work at Maker Faire 2011!
The Turnigy 9X is an inexpensive and highly hackable transmitter for remote controlled aircraft. This guide will show how to change a Turnigy 9X from Mode 1 (with the throttle on the right and elevator on the left) to Mode 2 (with the throttle on the left and the elevator on the right). [ … ] Thanks to Miro at iFixit for photographing this guide while I performed the work at Maker Faire 2011!
Time Required Min
15 minuten
Time Required Max
15 minuten
Difficulty
Moderate
Easy
Conclusion
To reassemble your device, follow these change from Mode 2 to Mode 1, use the same instructions in reverse order. but swap the left and right stick references.
To reassemble your device, follow these change from Mode 2 to Mode 1, use the same instructions in reverse order. but swap the left and right stick references.
Public
Nee
Ja

Gereedschap

  • Flathead Screwdriver x1 added.
  • Large Needle Nose Pliers x1 added.
  • Paper Clip x1 added.
  • Phillips head screwdriver x1 added.

Markeringen

  • In Progress removed.