Ga door naar hoofdinhoud

Wijzigingen in Apple Watch Series 1 Force Touch Sensor Replacement introductie

Bewerken voor Tobias Isakeit

Bewerking goedgekeurd door Tobias Isakeit

Verwijderd
Toegevoegd
Ongewijzigd
Apparaat
[ ]Apple Watch Series 1
Type
[ ]replacement
Thing
[ ]Force Touch Sensor
Title
[ ]Apple Watch Series 1 Force Touch Sensor Replacement
Introduction
Unfortunately, opening up your Apple Watch may damage the Force Touch Sensor, which also serves as a gasketing seal. The sensor is made up of two layers, glued together. These layers may separate when you open your watch, compromising its seal after reassembly. If this happens, you'll need to repair or replace the sensor before reassembling your watch. [ … ] Be sure to follow our [guide|41083] guide when you're done.
Time Required Min
1 uur
Time Required Max
2 uren
Imageid
Voor
Na
Difficulty
Difficult
Conclusion
[ ]To continue reassembling your device, follow our [guide|41083] guide.
Author
Public
Nee
Summary
[ ]Replace or repair the Force Touch Sensor on your Apple Watch Series 1.

Handleidingsbenodigdheden

Gereedschap

  • iOpener x1 added.
  • iFixit Opening Tools x1 added.
  • iFixit Opening Picks set of 6 x1 added.
  • Curved Razor Blade x1 added.
  • Tweezers x1 added.
  • 1.0 mm Flathead Screwdriver x1 added.
  • Tri-point Y000 Driver Bit x1 added.

Onderdelen

  • Apple Watch (38 mm) Replacement Battery x1 added.
  • Apple Watch (42 mm, Original & Series 1) Replacement Battery x1 added.
  • Apple Watch Battery Connector Bracket x1 added.
  • Apple Watch (38 mm, Original & Series 1) Screen x1 added.
  • Apple Watch (42 mm, Original & Series 1) Screen x1 added.
  • Apple Watch (38 mm, Original & Series 1) Force Touch Sensor Adhesive Gasket x1 added.
  • Apple Watch (42 mm, Original & Series 1) Force Touch Sensor Adhesive Gasket x1 added.
  • Apple Watch (38 mm) Adhesive Strips x1 added.
  • Apple Watch (42 mm) Adhesive Strips x1 added.

Markeringen

  • In Progress added.