Inleiding

If the device does not start and the Sensor Lens is in good condition, then the Circuit Board may be faulty and need replacement.

  1. Begin by removing both screws and the brushed metal casing. Simply lift up at the indicated area with your hand.
    • Begin by removing both screws and the brushed metal casing. Simply lift up at the indicated area with your hand.

    • The INSTALL and REMOVE indicators may be incorrect, so exercise caution when removing the screws.

    Voeg opmerking toe

  2. Remove both 3/8" Ph2 screws attached to the grey belt at the top and bottom.
    • Remove both 3/8" Ph2 screws attached to the grey belt at the top and bottom.

    • Lift the grey belt away. This gives access to the server board.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Remove all three 1/2" Ph1 screws connecting the server board to the device.

    • During reassembly, install the screws before reattaching the wires.

    Voeg opmerking toe

    • Use a plastic opening tool to remove the two pink capped wires in the upper left corner of the server board.

    • Use the same tool to dislodge the white capped ribbon bus with the multi-colored wires.

    • After these steps, the server board should easily come off the side of the device.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Blane Hirsh

Lid sinds: 17-09-18

255 Reputatie

2 handleidingen geschreven

Team

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 10

Afgelopen 7 Dagen: 24

Afgelopen 30 Dagen: 32

Altijd: 49