Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Inleiding

This guide will demonstrate how to replace the back cover of the Balance Board.

  1. Flip device upside-down so the plastic white board is facing the ground.
    • Flip device upside-down so the plastic white board is facing the ground.

    • Locate the four feet in the corners of the Balance Board.

    • Unscrew the three 12.7 mm Phillips screws from each foot cover.

  2. Remove the gray plastic ring from the actual foot by lifting it up.
    • Remove the gray plastic ring from the actual foot by lifting it up.

  3. SLA DE UPGRADE OVER

    Bespaar door het te repareren met een alles-in-één kit.

    Koop iPhone-reparatiekits

    SLA DE UPGRADE OVER

    Bespaar door het te repareren met een alles-in-één kit.

    Koop iPhone-reparatiekits
  4. Separate the loose foot from the device by lifting it up.
    • Separate the loose foot from the device by lifting it up.

  5. Repeat steps two and three on the remaining four feet.
    • Repeat steps two and three on the remaining four feet.

  6. Unscrew the ten 12.7 mm Phillips #1 screws.
    • Unscrew the ten 12.7 mm Phillips #1 screws.

  7. Lift off the gray back cover.
    • Lift off the gray back cover.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Cory Olson

Lid sinds: 29-09-14

768 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 13-8, Forte Fall 2014 Lid van Cal Poly, Team 13-8, Forte Fall 2014

CPSU-FORTE-F14S13G8

5 Leden

10 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 3

Afgelopen 30 dagen: 10

Altijd: 525