Ga door naar hoofdinhoud

Inleiding

Hello all, today we will repair a water damaged phone.

it's a simple cell phone and quite easy to repair.

enjoy

Onderdelen

Geen onderdelen opgegeven.

  1. Remove back cover & battery. Remove back cover & battery. Remove back cover & battery.
    • Remove back cover & battery.

  2. Remove the front case by prying it open. You will hear clicks. Be careful with taking off screen if you use a spudger.
    • Remove the front case by prying it open. You will hear clicks.

    • Be careful with taking off screen if you use a spudger.

  3. Use a Torx screwdriver to remove the screen screws. Use a spudger or tweezers to remove the connector of the LCD screen.
    • Use a Torx screwdriver to remove the screen screws.

    • Use a spudger or tweezers to remove the connector of the LCD screen.

  4. Remove keyboard by prying it open with a spudger. The keyboard is secured with adhesive, be careful! The keyboard is secured with adhesive, be careful!
    • Remove keyboard by prying it open with a spudger.

    • The keyboard is secured with adhesive, be careful!

  5. The PCB board had water damage, see this in picture 3. To remove the corrosion, dab a cotton swab with a little distilled water on the corroded area, the corrosion will disappear. To remove the corrosion, dab a cotton swab with a little distilled water on the corroded area, the corrosion will disappear.
    • The PCB board had water damage, see this in picture 3.

    • To remove the corrosion, dab a cotton swab with a little distilled water on the corroded area, the corrosion will disappear.

  6. How and where to use the cotton swabs. How and where to use the cotton swabs.
    • How and where to use the cotton swabs.

Conclusie

To reassemble your device, follow these instructions in reverse order.

13 andere personen hebben deze handleiding voltooid.

Kevin D

Lid sinds: 02-05-14

6.268 Reputatie

21 handleidingen geschreven

no use .it is not switching on . replaced with good batter also. no on

nabhan75 - Antwoord

try to clean with an ultrasonic bath.

measure out powerrail.

measure out the voltage coming in on board. try to see if you have short.

Kevin D - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 6

Afgelopen 30 Dagen: 35

Altijd: 9,631