Inleiding

If your watch will not turn on there is a chance that your master switch is stuck or not functioning properly. The following guide will show you how to replace one of the most essential buttons on the Vtech Kidizoom Smart Watch DX.

Onderdelen

Geen onderdelen nodig.

  1. Begin by flipping the watch over with its back facing upwards. Begin by flipping the watch over with its back facing upwards.
    • Begin by flipping the watch over with its back facing upwards.

  2. Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate. Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.
    • Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.

  3. Gratis verzending van alle bestellingen van meer dan US$ 100 of met een Pro Tech Toolkit!

    Doorblader onze winkel
  4. Gently lift the backplate up to remove it. Gently lift the backplate up to remove it.
    • Gently lift the backplate up to remove it.

  5. After removing the backplate, lift the master switch up from the circuit board. After removing the backplate, lift the master switch up from the circuit board. After removing the backplate, lift the master switch up from the circuit board.
    • After removing the backplate, lift the master switch up from the circuit board.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Sydney

Lid sinds: 25-10-18

269 Reputatie

2 handleidingen geschreven

Team

UMass Dartmouth, Team S3-G5, Peak Fall 2018 Lid van UMass Dartmouth, Team S3-G5, Peak Fall 2018

UMASSD-PEAK-F18S3G5

4 Leden

7 handleidingen geschreven

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 2

Afgelopen 30 Dagen: 8

Altijd: 96