Onderdelen

Geen onderdelen nodig.

Flip the mouse over and peel off the stickers on the perimeter of the bottom of the mouse
  • Flip the mouse over and peel off the stickers on the perimeter of the bottom of the mouse

my mouse sucks i peeled off the tape and there is a layer of something blocking the the screw it is a gaming mouse and i got it 2 weeks ago

Nathan Swercewski - Antwoord

Use the Phillips #1 screwdriver to unscrew the six round head screws on the bottom of the mouse. Those marked with squares are 9 mm in length, the rest are 5 mm in length. Use the Phillips #1 screwdriver to unscrew the six round head screws on the bottom of the mouse. Those marked with squares are 9 mm in length, the rest are 5 mm in length.
  • Use the Phillips #1 screwdriver to unscrew the six round head screws on the bottom of the mouse. Those marked with squares are 9 mm in length, the rest are 5 mm in length.

Voeg opmerking toe

Grab the top shell of the mouse and lift up to remove. Grab the top shell of the mouse and lift up to remove. Grab the top shell of the mouse and lift up to remove.
  • Grab the top shell of the mouse and lift up to remove.

Voeg opmerking toe

The capacitors on this board can release stored electrical energy if touched.
  • The capacitors on this board can release stored electrical energy if touched.

  • Touch your capacitor discharge tool to the capacitor leads on the board to release the stored energy. If leads are inaccessible, wait until you've removed the board from the mouse body.

Voeg opmerking toe

To remove the white wire connector on the bottom board, use a spudger underneath the white plug and pop it out (this disconnects the upper board from the lower board). To remove the white wire connector on the bottom board, use a spudger underneath the white plug and pop it out (this disconnects the upper board from the lower board).
  • To remove the white wire connector on the bottom board, use a spudger underneath the white plug and pop it out (this disconnects the upper board from the lower board).

Voeg opmerking toe

Remove the 5 mm round head screw holding the middle piece to the top piece.
  • Remove the 5 mm round head screw holding the middle piece to the top piece.

  • The outermost shell will now separate from the middle structure.

Voeg opmerking toe

Using the Phillips #1 screwdriver, unscrew the 5 mm black flat head screw that's securing the scroll wheel cage.
  • Using the Phillips #1 screwdriver, unscrew the 5 mm black flat head screw that's securing the scroll wheel cage.

Voeg opmerking toe

Pinch the cage to release snaps. You can now pull the cage off. Pinch the cage to release snaps. You can now pull the cage off.
  • Pinch the cage to release snaps. You can now pull the cage off.

Voeg opmerking toe

Remove the screw holding the circuit board down.
  • Remove the screw holding the circuit board down.

  • The board will now pop off easily.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

David

Lid sinds: 16-01-13

647 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 18-36, Regan Winter 2013 Lid van Cal Poly, Team 18-36, Regan Winter 2013

CPSU-REGAN-W13S18G36

3 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 4

Altijd: 469