Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Inleiding

This guide will show users how to fix the stretcher of an umbrella by using a thin piece of copper wire in place of where the rivet once was.

URL for half-hitch knot:

http://www.animatedknots.com/halfhitch/#...

Onderdelen

  1. Open the umbrella into its proper position.
    • Open the umbrella into its proper position.

  2. Identify the broken stretcher that needs to be repaired.
    • Identify the broken stretcher that needs to be repaired.

  3. Close the umbrella halfway to release the tension in the stretchers.
    • Close the umbrella halfway to release the tension in the stretchers.

    • This makes it easier to line up the holes in the next step.

  4. Take the two pieces of the broken stretcher and line up the rivet holes.
    • Take the two pieces of the broken stretcher and line up the rivet holes.

  5. LCD iPhone-scherm fixkits

    De goedkope optie, ondersteund door onze levenslange garantie.

    Koop kits

    LCD iPhone-scherm fixkits

    Bespaar op reparatiekosten, niet op kwaliteit.

    Koop kits
  6. Pass the 6" piece of wire through the rivet holes.
    • Pass the 6" piece of wire through the rivet holes.

  7. Wrap the wire around the stretcher and thread it through the holes again.
    • Wrap the wire around the stretcher and thread it through the holes again.

    • Repeat until there is no more room to pass the wire through.

    • May need to use the pliers to get a better grip on the wire so it can be pulled tight.

  8. Tie two half-hitch knots with the wire.
    • Tie two half-hitch knots with the wire.

    • If you do not know how to tie a half-hitch knot, follow the link provided at the beginning of the guide.

  9. Use the scissors to trim the two ends of the wire to about half an inch in length.
    • Use the scissors to trim the two ends of the wire to about half an inch in length.

  10. Using the pliers, twist the ends of the wire together.
    • Using the pliers, twist the ends of the wire together.

  11. Tuck the wires down and clamp with the pliers so the ends are not poking out.
    • Tuck the wires down and clamp with the pliers so the ends are not poking out.

Eindstreep

3 andere personen hebben deze handleiding voltooid.

Alexandra Hamelin

Lid sinds: 08-06-16

201 Reputatie

1 Handleiding geschreven

Team

Texas Tech, Team 3-8, Rauch SU 2016 Lid van Texas Tech, Team 3-8, Rauch SU 2016

TTU-RAUCH-SU16S3G8

2 Leden

2 handleidingen geschreven

Één commentaar

This is not called an ‘umbrella rivet replacement’.

SouthPark - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 8

Afgelopen 7 dagen: 35

Afgelopen 30 dagen: 113

Altijd: 3,800