Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Inleiding

This guide outlines the steps needed to replace the impeller spindle. The spindle is the shaft that the impeller spins around.

  1. Hold the inlet screen and rotate it counterclockwise to unscrew it. It is helpful to remove the inlet screen so that it is not damaged during the replacement process. Hold the inlet screen and rotate it counterclockwise to unscrew it. It is helpful to remove the inlet screen so that it is not damaged during the replacement process. Hold the inlet screen and rotate it counterclockwise to unscrew it. It is helpful to remove the inlet screen so that it is not damaged during the replacement process.
    • Hold the inlet screen and rotate it counterclockwise to unscrew it. It is helpful to remove the inlet screen so that it is not damaged during the replacement process.

  2. Firmly hold the pump block with one hand and the impeller housing with the other hand. Rotate impeller housing counterclockwise until it is released. Firmly hold the pump block with one hand and the impeller housing with the other hand. Rotate impeller housing counterclockwise until it is released. Firmly hold the pump block with one hand and the impeller housing with the other hand. Rotate impeller housing counterclockwise until it is released.
    • Firmly hold the pump block with one hand and the impeller housing with the other hand. Rotate impeller housing counterclockwise until it is released.

  3. OPEN ALLE TABBLADEN

    RAM-upgradekits voor Mac

    Koop kits

    Genoeg RAM
    voor al je tabbladen

    Koop kits
  4. Remove the rubber stop that is attached to the tube that runs through the middle of the impeller. Also remove the bearing that is between the stop and the impeller. Remove the rubber stop that is attached to the tube that runs through the middle of the impeller. Also remove the bearing that is between the stop and the impeller.
    • Remove the rubber stop that is attached to the tube that runs through the middle of the impeller. Also remove the bearing that is between the stop and the impeller.

  5. Hold the impeller cover with one hand and the impeller with the other. Slide the impeller out. Hold the impeller cover with one hand and the impeller with the other. Slide the impeller out.
    • Hold the impeller cover with one hand and the impeller with the other. Slide the impeller out.

  6. Hold the impeller spindle and wiggle it side to side until it detaches from the impeller cover. Hold the impeller spindle and wiggle it side to side until it detaches from the impeller cover.
    • Hold the impeller spindle and wiggle it side to side until it detaches from the impeller cover.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Nicole Santana

Lid sinds: 13-01-15

597 Reputatie

5 handleidingen geschreven

Team

USF Tampa, Team 3-6, Hickman Winter 2015 Lid van USF Tampa, Team 3-6, Hickman Winter 2015

USFT-HICKMAN-W15S3G6

4 Leden

5 handleidingen geschreven

Één commentaar

The part number of the spindle itself would probably be a good idea to included in this guide.

rz22g - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 2

Afgelopen 7 dagen: 4

Afgelopen 30 dagen: 12

Altijd: 991