Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Inleiding

This guide will demonstrate how to dismantle and replace components of your computers display (screen).

  1. Carefully pry the panel above the keyboard from both sides of the laptop using the iFixit opening tool. Push back the screen until it is horizontal with the laptop. Gently remove the clips that connect the panel to the screen.
    • Carefully pry the panel above the keyboard from both sides of the laptop using the iFixit opening tool.

    • Push back the screen until it is horizontal with the laptop.

    • Gently remove the clips that connect the panel to the screen.

  2. Remove the two screws using a Phillips #1 screwdriver. Gently pry the keyboard from the laptop using the iFixit opening tool. Slowly lift the keyboard away from the laptop until you are able to remove the ribbon that connects to the laptop.
    • Remove the two screws using a Phillips #1 screwdriver.

    • Gently pry the keyboard from the laptop using the iFixit opening tool.

    • Slowly lift the keyboard away from the laptop until you are able to remove the ribbon that connects to the laptop.

    • Ensure you remove the keyboard slowly to avoid damaging the ribbon cable.

  3. Remove the 2-3 pieces of black electrical tape covering the black-and-white antenna cable.
    • Remove the 2-3 pieces of black electrical tape covering the black-and-white antenna cable.

    • Close the display, flip the laptop over, and disconnect the black-and-white antenna cables from the Wi-Fi card.

    • Flip the laptop back over and open the display.

  4. Remove the two Phillips #1 screws securing the display hinges. It is recommended to keep the screws in a small cup so that you don't lose them. Remove the four Phillips #1 screws on the back of the laptop.
    • Remove the two Phillips #1 screws securing the display hinges.

    • It is recommended to keep the screws in a small cup so that you don't lose them.

    • Remove the four Phillips #1 screws on the back of the laptop.

  5. Gently pull up on the display's video connector to remove it.
    • Gently pull up on the display's video connector to remove it.

    • Remove the black-and-white antenna cable from the groove.

    • Your display can now be removed.

Conclusie

To reassemble your device, follow these instructions in reverse order.

3 andere personen hebben deze handleiding voltooid.

Aryn Pauly

Lid sinds: 29-04-10

1 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 10-42, Garner Spring 2010 Lid van Cal Poly, Team 10-42, Garner Spring 2010

CPSU-GARNER-S10S10G42

5 Leden

10 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 1

Altijd: 7,979