1. Unscrew the three screws from the back panel with Phillips #0 screwdriver.
    • Unscrew the three screws from the back panel with Phillips #0 screwdriver.

    • Remove the back panel.

    Voeg opmerking toe

  2. Locate the two clips holding the RAM chip in place.
    • Locate the two clips holding the RAM chip in place.

    • Apply pressure to each clip, pulling them away from the RAM.

    • One end of the RAM will pop out.

    Voeg opmerking toe

    • Gently pull RAM out as shown.

    Voeg opmerking toe

    • To intall a new stick of RAM, carefully insert it into into the RAM slot.

    • Gently push down on the RAM chip until it snaps securely into place.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Michael Jensen

Lid sinds: 18-04-11

417 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 4-3, Regan Spring 2011 Lid van Cal Poly, Team 4-3, Regan Spring 2011

CPSU-REGAN-S11S4G3

5 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 2,547