Ga door naar hoofdinhoud

Inleiding

This guide will inform readers on how to replace the optical drive which may have stopped reading disks.

  1. Turn the laptop over to place it top down. Use a Phillips #1 screwdriver to remove the screw holding in the back plate. This screw does not come out of the plate. Lift the back plate off the laptop, exposing the RAM and Hard Disk.
    • Turn the laptop over to place it top down.

    • Use a Phillips #1 screwdriver to remove the screw holding in the back plate. This screw does not come out of the plate.

    • Lift the back plate off the laptop, exposing the RAM and Hard Disk.

  2. Using a Phillips #0 screwdriver, remove the single 3mm screw. Using a Phillips #0 screwdriver, remove the single 3mm screw.
    • Using a Phillips #0 screwdriver, remove the single 3mm screw.

  3. Rotate the laptop so that you have access to the optical drive. The optical drive is now only attached by a port in the drive's back. The optical drive can be pulled straight out of its housing.
    • Rotate the laptop so that you have access to the optical drive.

    • The optical drive is now only attached by a port in the drive's back. The optical drive can be pulled straight out of its housing.

    • Remove the drive.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Tyler Shafer

Lid sinds: 12-02-18

420 Reputatie

3 handleidingen geschreven

Team

0 Opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 2

Afgelopen 30 dagen: 5

Altijd: 159