1. Use a bit driver and a Phillips #0 bit to remove the one 5 mm retaining screw.
    • Use a bit driver and a Phillips #0 bit to remove the one 5 mm retaining screw.

    • Lift the panel up and out of the way.

    Voeg opmerking toe

  2. The RAM chip is secured by two retaining arms that run parallel with the chip. Gently pull these arms in opposite directions off of the chip.
    • The RAM chip is secured by two retaining arms that run parallel with the chip. Gently pull these arms in opposite directions off of the chip.

    • After the retainer arms are free, push the chip towards the top of the netbook. This will free the chip for removal.

    Voeg opmerking toe

    • Push the replacement RAM into the original position.

    • Reattach both securing arms onto the sides of the RAM chip.

    Voeg opmerking toe

    • Place the panel back into the securing slots and let it rest in its original position.

    • With the bit driver and Phillips #0 bit, secure the panel down with one screw.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Mason McCaskill

Lid sinds: 18-10-13

943 Reputatie

9 handleidingen geschreven

Team

Clemson, Team 14-2, Benson Fall 2013 Lid van Clemson, Team 14-2, Benson Fall 2013

CLEM-BENSON-F13S14G2

3 Leden

9 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 282