Repareer je spullen Gemeenschap Winkel

Engage Wired Optical Mouse Top and Outer Shell Removal

Inleiding

The first step of disassembling the Engage Wired Optical Mouse is to remove the outer shell and main top component of the mouse without damaging any parts.

Note that the circuit board has capacitors. Though they aren't very dangerous, you may wish to discharge them before handling the circuit board. A tool to accomplish this can be found here.

Wat je nodig hebt

  1. Engage Wired Optical Mouse Top and Outer Shell Removal, Engage Wired Optical Mouse Top and Outer Shell Removal: stap 1, afbeelding 1 van 1

    • Flip the mouse over and peel off the stickers on the perimeter of the bottom of the mouse.

    Bewerken

  2. Engage Wired Optical Mouse Top and Outer Shell Removal: stap 2, afbeelding 1 van 1

    • Use the Phillips #1 screwdriver to remove four 5 mm screws from the bottom of the mouse.

    • Use the Phillips #1 screwdriver to remove the two 9 mm screws from the bottom of the mouse.

    Bewerken

  4. Engage Wired Optical Mouse Top and Outer Shell Removal: stap 3, afbeelding 1 van 3 Engage Wired Optical Mouse Top and Outer Shell Removal: stap 3, afbeelding 2 van 3 Engage Wired Optical Mouse Top and Outer Shell Removal: stap 3, afbeelding 3 van 3

    • Grab the top shell of the mouse and lift up to remove.

    Bewerken

  5. Engage Wired Optical Mouse Top and Outer Shell Removal: stap 4, afbeelding 1 van 1

    • The capacitors on this board can release stored electrical energy if touched.

    • Touch your capacitor discharge tool to the capacitor leads on the board to release the stored energy. If leads are inaccessible, wait until you've removed the board from the mouse body.

    Bewerken

  6. Engage Wired Optical Mouse Top and Outer Shell Removal: stap 5, afbeelding 1 van 2 Engage Wired Optical Mouse Top and Outer Shell Removal: stap 5, afbeelding 2 van 2

    • Use a spudger to pry underneath the white plug and pop it out to disconnect the upper board from the lower board.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Auteur

met 6 andere bijdragers

royceeklund

Lid sinds: 01/18/13

79 Reputatie

3 handleidingen geschreven

Medailles: 9

+6 andere badges

Team

Cal Poly, Team 18-36, Regan Winter 2013 Lid van Cal Poly, Team 18-36, Regan Winter 2013

CPSU-REGAN-W13S18G36

3 Leden

30 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 7

Afgelopen 30 dagen: 19

Altijd: 3,405