1. Peel back the sticker, using the tweezers on the bottom of the device to reveal the two screws.
    • Peel back the sticker, using the tweezers on the bottom of the device to reveal the two screws.

    Voeg opmerking toe

  2. Unscrew the two T5 screws using the T5 Torx Screwdriver.
    • Unscrew the two T5 screws using the T5 Torx Screwdriver.

    Voeg opmerking toe

    • Insert the flat head screwdriver into the edge of the device. Using it as a lever, carefully pry the face-plate up.

    Voeg opmerking toe

    • Carefully grab the ribbon cable with two fingers and pull the yellow ribbon cable upwards away from the motherboard.

    Voeg opmerking toe

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the screen from of the face-plate.

    Voeg opmerking toe

    • Insert the new screen into the face-plate.

    Voeg opmerking toe

    • Reattach the yellow ribbon cable to the motherboard.

    Voeg opmerking toe

    • Using two hands, hold both ends of the device and snap the two plates together.

    Voeg opmerking toe

    • Re-insert the two T5 screws and tighten.

    Voeg opmerking toe

    • Re-apply the label edges back down to cover the screws.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Mike Sollars

Lid sinds: 11-07-13

471 Reputatie

3 handleidingen geschreven

Team

WRI115, Team 1-1, Ruszkiewicz Spring 2013 Lid van WRI115, Team 1-1, Ruszkiewicz Spring 2013

WRI115-RUSZKIEWICZ-S13S1G1

4 Leden

3 handleidingen geschreven

Één commentaar

Hi! Thanks for doing this. How do I release the yellow cable from the board?

Shaun B - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 2

Afgelopen 30 Dagen: 9

Altijd: 1,364