Inleiding

Overtime the motherboard's wires may come apart and make the device stop working. This guide will show you how to replace the motherboard with a new one.

Use a T-9 Torx screwdriver to  unscrew the four screws on the back cover.
  • Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.

Voeg opmerking toe

Using the spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device. Using the spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.
  • Using the spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.

Voeg opmerking toe

Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device.
  • Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device.

Voeg opmerking toe

Once the two covers are separated, use tweezers, or even your fingers, to gently disconnect the two sets of wires that are connected to the motherboard from the back cover.
  • Once the two covers are separated, use tweezers, or even your fingers, to gently disconnect the two sets of wires that are connected to the motherboard from the back cover.

Voeg opmerking toe

Next, you must remove the motherboard from the front screen.
  • Next, you must remove the motherboard from the front screen.

  • Use a Torx T-7 screwdriver to unscrew the two screws.

Voeg opmerking toe

Before you can seperate the motherboard from the front cover, you must disconnect the wire connecting the two. To do so, you must use the back end of the spudger to push out the two white tabs connected to the wire, that holds the motherboard and front cover together.
  • Before you can seperate the motherboard from the front cover, you must disconnect the wire connecting the two.

  • To do so, you must use the back end of the spudger to push out the two white tabs connected to the wire, that holds the motherboard and front cover together.

Voeg opmerking toe

The motherboard is now disconnected from the front assembly
  • The motherboard is now disconnected from the front assembly

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

Becca

Lid sinds: 16-04-10

202 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 7-7, Maness Spring 2010 Lid van Cal Poly, Team 7-7, Maness Spring 2010

CPSU-MANESS-S10S7G7

4 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 6

Altijd: 9,714