Ga door naar hoofdinhoud

Deze handleiding heeft recentere wijzigingen. Schakel over naar de nieuwste niet-geverifieerde versie.

TomTom ONE Front Cover Replacement

Wat je nodig hebt

  1. TomTom ONE Front Cover Replacement, Screen: stap 1, afbeelding 1 van 1
    • Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.

  2. TomTom ONE Front Cover Replacement: stap 2, afbeelding 1 van 2 TomTom ONE Front Cover Replacement: stap 2, afbeelding 2 van 2
    • Using the spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.

  3. TomTom ONE Front Cover Replacement: stap 3, afbeelding 1 van 1
    • Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device.

  4. TomTom ONE Front Cover Replacement: stap 4, afbeelding 1 van 1
    • Once the two covers are separated, use the tweezers, or even your fingers, to gently disconnect the two sets of wires that are connected to the motherboard from the back cover. You may have to wiggle the wires a little bit to get them to disconnect.

  5. TomTom ONE Front Cover Replacement: stap 5, afbeelding 1 van 1
    • Next, you must remove the motherboard from the front screen.

    • Use a Torx T-7 screwdriver to unscrew the two screws.

  6. TomTom ONE Front Cover Replacement: stap 6, afbeelding 1 van 2 TomTom ONE Front Cover Replacement: stap 6, afbeelding 2 van 2
    • Before you can seperate the motherboard from the front cover, you must disconnect the wire connecting the two.

    • To do so, you must use the back end of the spudger to push out the two white tabs connected to the wire, that holds the motherboard and front cover together.

  7. TomTom ONE Front Cover Replacement: stap 7, afbeelding 1 van 1
    • Once separated, use the spudger to pry around the edges of the outer casing.

  8. TomTom ONE Front Cover Replacement: stap 8, afbeelding 1 van 2 TomTom ONE Front Cover Replacement: stap 8, afbeelding 2 van 2
    • Apply pressure with thumbs to remove screen from inner casing.

    • The screen and front cover are now disconnected.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Trevor Foster

Lid sinds: 04/18/10

145 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 7-7, Maness Spring 2010 Lid van Cal Poly, Team 7-7, Maness Spring 2010

CPSU-MANESS-S10S7G7

4 Leden

6 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 4,267