Menu

Jouw instellingen

Mijn werkbank

Krijg snel toegang tot handleidingen, onderdelen en antwoorden voor jouw apparaten
Winkelwagen

Het lijkt erop dat je mandje leeg is

Doorblader onze winkel

TomTom ONE Battery Replacement

Geschreven door: Trevor Foster (en 6 andere bijdragers)
  • Reacties: 0
  • Favorieten: 12
  • Voltooide reparaties: 2

Moeilijkheid

Gemiddeld

Stappen

5

Tijd vereist

20 - 40 minuten

Secties

1

Markeringen

0

Inleiding

Batteries do not last forever, so this guide is to show you how to replace the battery.

Gereedschap

Koop deze gereedschappen

Onderdelen

Geen onderdelen opgegeven.

  1. Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.

    • Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.

    Bewerken

  2. Using a spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device. Using a spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.

    • Using a spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.

    Bewerken

  3. PC Laptop batterijen

    An easy fix for a big power boost.

    Nu winkelen

    PC Laptop batterijen

    An easy fix for a big power boost.

    Nu winkelen

  4. Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device.

    • Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device.

    Bewerken

  5. Once the two covers are separated, use the tweezers, or even your fingers, to gently disconnect the two sets of wires that are connected to the motherboard from the back cover. You may have to wiggle the wires a little bit to get them to disconnect.

    • Once the two covers are separated, use the tweezers, or even your fingers, to gently disconnect the two sets of wires that are connected to the motherboard from the back cover. You may have to wiggle the wires a little bit to get them to disconnect.

    Bewerken

  6. Using the spudger, gently pry out the battery. The battery may seem tough to get out due to the adhesive used to secure it. Just slowly work at it and do not force anything.

    • Using the spudger, gently pry out the battery.

    • The battery may seem tough to get out due to the adhesive used to secure it. Just slowly work at it and do not force anything.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Auteur

met 6 andere bijdragers

Trevor Foster

Lid sinds: 18-04-10

142 Reputatie

3 handleidingen geschreven

Badges: 11

+8 andere badges

Team

Cal Poly, Team 7-7, Maness Spring 2010 Lid van Cal Poly, Team 7-7, Maness Spring 2010

CPSU-MANESS-S10S7G7

4 Leden

6 handleidingen geschreven

0 Opmerkingen

Een opmerking toevoegen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 10

Afgelopen 30 Dagen: 40

Altijd: 9,693