Inleiding

Batteries do not last forever, so this guide is to show you how to replace the battery.

Onderdelen

Geen onderdelen nodig.

  1. Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.
    • Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.

    Voeg opmerking toe

  2. Using a spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.
    • Using a spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.

    Voeg opmerking toe

    • Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device.

    Voeg opmerking toe

    • Once the two covers are separated, use the tweezers, or even your fingers, to gently disconnect the two sets of wires that are connected to the motherboard from the back cover. You may have to wiggle the wires a little bit to get them to disconnect.

    Voeg opmerking toe

    • Using the spudger, gently pry out the battery.

    • The battery may seem tough to get out due to the adhesive used to secure it. Just slowly work at it and do not force anything.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Trevor Foster

Lid sinds: 18-04-10

142 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 7-7, Maness Spring 2010 Lid van Cal Poly, Team 7-7, Maness Spring 2010

CPSU-MANESS-S10S7G7

4 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 6

Afgelopen 30 Dagen: 24

Altijd: 9,401