Onderdelen

Geen onderdelen nodig.

  1. Power down the TiVo and detach the power cable from the rear of the unit.
    • Power down the TiVo and detach the power cable from the rear of the unit.

      • Wait 5 minutes for the unit to fully discharge before proceeding to the next step.

  2. Remove the five T10 screws from the rear of the case using the Torx screwdriver.
    • Remove the five T10 screws from the rear of the case using the Torx screwdriver.

    • Lift up and pull back the outer casing towards the rear of the unit.

    • Disconnect the power to the hard drive.

    • Grab the hard drive data cable from both sides of the connector and unplug it from the hard drive.

      • Use extreme caution when unplugging connector and do not disconnect the data cable by pulling on the cable itself.

    • Unscrew the two screws on the case of the hard drive with a T10 screwdriver.

    • Pull the hard drive up and out of the TiVo unit.

    • Unscrew the four screws, shown in the picture, with a T-10 screwdriver.

    • Remove the hard drive from the case.

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Svyatoslav Markeyev

Lid sinds: 16-04-10

135 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 33-79, Johann Spring 2010 Lid van Cal Poly, Team 33-79, Johann Spring 2010

CPSU-JOHANN-S10S33G79

4 Leden

5 handleidingen geschreven

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 14

Altijd: 6,853