Inleiding

In case your remote just won't work and you have already tried replacing the batteries, this guide will walk you through removing the front cover and replacing the remote sensor on the inside of the cover.

Onderdelen

Geen onderdelen nodig.

Unscrew the five 0.31 inch T-9 screws on the back cover.
  • Unscrew the five 0.31 inch T-9 screws on the back cover.

Voeg opmerking toe

Slide the cover towards the back until it is no longer under the front cover.
  • Slide the cover towards the back until it is no longer under the front cover.

Voeg opmerking toe

  • Lift the cover up and off the device.

Voeg opmerking toe

  • Unplug the ribbon cable from the motherboard. Some force may be required for this step, so be careful not to rip the ribbon cable.

Voeg opmerking toe

  • Unscrew the two 0.31 inch T-9 screws on the inside of the front cover.

Voeg opmerking toe

  • Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover.

Voeg opmerking toe

  • Pull the front cover down and away from the device to separate it completely. Be careful not to tear the ribbon cable as you are removing the front cover.

Voeg opmerking toe

  • Unscrew the two 0.31 inch T-9 screws on the back of the sensor.

Voeg opmerking toe

  • Lift the sensor up to remove it.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Shauna

Lid sinds: 10-10-11

37 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 5-33, Amido Fall 2011 Lid van Cal Poly, Team 5-33, Amido Fall 2011

CPSU-AMIDO-F11S5G33

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 2

Altijd: 899