Ga door naar hoofdinhoud

Texas Instruments TI-5130 Power Cord Replacement

Wat je nodig hebt

  1. Texas Instruments TI-5130 Power Cord Replacement, Power Cord: stap 1, afbeelding 1 van 2 Texas Instruments TI-5130 Power Cord Replacement, Power Cord: stap 1, afbeelding 2 van 2
    • Flip the calculator over and remove the 4 main 10mm screws with a PH1 screwdriver.

  2. Texas Instruments TI-5130 Power Cord Replacement: stap 2, afbeelding 1 van 2 Texas Instruments TI-5130 Power Cord Replacement: stap 2, afbeelding 2 van 2
    • Remove the top cover.

    • Gently pull up on the power cord to remove it from the back cover.

  3. Texas Instruments TI-5130 Power Cord Replacement: stap 3, afbeelding 1 van 2 Texas Instruments TI-5130 Power Cord Replacement: stap 3, afbeelding 2 van 2
    • This step is optional; however it makes it easier to work.

    • Using a PH1 screwdriver remove the two 10mm screws that hold down the transformer.

    • Gently remove the transformer.

    • Make sure that the calculator is not plugged in.

  4. Texas Instruments TI-5130 Power Cord Replacement: stap 4, afbeelding 1 van 2 Texas Instruments TI-5130 Power Cord Replacement: stap 4, afbeelding 2 van 2
    • Use a wire cutter to cut off the white cap and expose the wires. Try to cut close to the tip of the white cap - to leave as much wire as possible.

    • Note that there are 2 sets of wires connected to the power cord. Do each set of wires separately.

  5. Texas Instruments TI-5130 Power Cord Replacement: stap 5, afbeelding 1 van 2 Texas Instruments TI-5130 Power Cord Replacement: stap 5, afbeelding 2 van 2
    • Use a wire stripper to remove 1/2” of the protective covering on each of the wires.

  6. Texas Instruments TI-5130 Power Cord Replacement: stap 6, afbeelding 1 van 2 Texas Instruments TI-5130 Power Cord Replacement: stap 6, afbeelding 2 van 2
    • Twist the exposed section of the 2 wires together.

    • Twist a new cap over the exposed wires. Make sure that the cap covers all of the exposed wire.

    • Repeat steps 4-6 for the second set of wires.

  7. Texas Instruments TI-5130 Power Cord Replacement: stap 7, afbeelding 1 van 1
    • Replace the transformer and ensure that the new wire caps fit in the space shown.

    • Plug in the new power cord and test the calculator before replacing the top cover.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Shannon Perkins

Lid sinds: 09/17/15

652 Reputatie

3 handleidingen geschreven

Team

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 3

Altijd: 487