Ga door naar hoofdinhoud

TRS-80 Color Computer Keyboard Replacement

Wat je nodig hebt

  1. TRS-80 Color Computer Keyboard Replacement, Outside Casing: stap 1, afbeelding 1 van 1
    • Flip the computer over.

    • Remove the two 24.1mm Phillips screws near the front of the case.

    • Remove the five 33.0 mm Phillips screws towards the back of the case.

  2. TRS-80 Color Computer Keyboard Replacement: stap 2, afbeelding 1 van 2 TRS-80 Color Computer Keyboard Replacement: stap 2, afbeelding 2 van 2
    • Carefully flip the computer right side up.

    • Lift off the top half of the case.

  3. TRS-80 Color Computer Keyboard Replacement, Keyboard: stap 3, afbeelding 1 van 2 TRS-80 Color Computer Keyboard Replacement, Keyboard: stap 3, afbeelding 2 van 2
    • Near the motherboard, gently pull the keyboard ribbon cable until it becomes free.

    • Lift the keyboard out of the case.

Conclusie

To reassemble your device, follow these instructions in reverse order.

3 andere personen hebben deze handleiding voltooid.

Christopher Paige

Lid sinds: 01/21/11

549 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 11-24, Maness Winter 2011 Lid van Cal Poly, Team 11-24, Maness Winter 2011

CPSU-MANESS-W11S11G24

4 Leden

10 handleidingen geschreven

Één opmerking

This only applies for Color Computers issued after the CoCo 1 F Board (as shown) RS catalog 26-3004 and subsequent models (CoCo 2 & 3). Early editions of the CoCo 1 had not a mylar ribbon cable like this but a heavier ribbon composed of actual wires, the connector they went into was also built for this type of ribbon. The keyboards on each category of connecting ribbon are sadly not interchangeable.

Rogelio Perea - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 16

Altijd: 3,187