Onderdelen

Geen onderdelen nodig.

Flip the phone over so that the screen is facing down.
  • Flip the phone over so that the screen is facing down.

Voeg opmerking toe

Push the gray lever up towards the top of the phone. Pull up on the battery pack and completely separate it from the phone.
  • Push the gray lever up towards the top of the phone.

  • Pull up on the battery pack and completely separate it from the phone.

Voeg opmerking toe

Locate the 5 screws around the back casing. Use a three-prong screw bit to remove all 5 screws
  • Locate the 5 screws around the back casing.

  • Use a three-prong screw bit to remove all 5 screws

Voeg opmerking toe

Use the plastic opening tool and slide it around the phone to pull apart the front and back casing.
  • Use the plastic opening tool and slide it around the phone to pull apart the front and back casing.

Voeg opmerking toe

Separate the two cases.
  • Separate the two cases.

Voeg opmerking toe

Use the plastic opening tool to remove the motherboard from the front case.
  • Use the plastic opening tool to remove the motherboard from the front case.

Voeg opmerking toe

Locate the 4 white clips of the dispaly. Locate the 4 white clips of the dispaly.
  • Locate the 4 white clips of the dispaly.

Voeg opmerking toe

Using the plastic opening tool, pull the white clips of the display away from the printed circuit board to unclip display. Using the plastic opening tool, pull the white clips of the display away from the printed circuit board to unclip display.
  • Using the plastic opening tool, pull the white clips of the display away from the printed circuit board to unclip display.

Voeg opmerking toe

Grasp the display on both sides and carefully pull the display off of the printed circuit board. Grasp the display on both sides and carefully pull the display off of the printed circuit board.
  • Grasp the display on both sides and carefully pull the display off of the printed circuit board.

Voeg opmerking toe

Using the plastic opening tool, carefully remove the yellow film covering the display connector. Do not damage the yellow film. Ensure that it stays in one piece and does not tear.
  • Using the plastic opening tool, carefully remove the yellow film covering the display connector.

    • Do not damage the yellow film. Ensure that it stays in one piece and does not tear.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Patrick Olmstead

Lid sinds: 22-10-13

240 reputatie

4 handleidingen geschreven

Team

Clemson, Team 13-5, Benson Fall 2013 Lid van Clemson, Team 13-5, Benson Fall 2013

CLEM-BENSON-F13S13G5

3 Leden

12 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 115