Inleiding

Sony Xperia Z2 (D6502, D6503, and D6543) - How to replace the Battery.


Please SUBSCRIBE to my channel ツ

Video overzicht

Switch off the phone. If you can't switch it off, you can use the OFF button near to the SIM card Tray. Warm the Back Cover. You can use a hairdryer.
  • Switch off the phone.

  • If you can't switch it off, you can use the OFF button near to the SIM card Tray.

  • Warm the Back Cover. You can use a hairdryer.

  • Be careful, the Back Cover is plastic.

Voeg opmerking toe

Use a small suction cup and plastic tools for separating the Rear panel. There is Adhesive tape on the edges of the phone and some between the Battery and the Back Cover, as well. I found a small tab to pull just inside the top of the cover that removed the adhesive and released the back panel from the battery. Its that same style adhesive strip as used in the Iphone 5/5c/5s. There is Adhesive tape on the edges of the phone and some between the Battery and the Back Cover, as well. I found a small tab to pull just inside the top of the cover that removed the adhesive and released the back panel from the battery. Its that same style adhesive strip as used in the Iphone 5/5c/5s.
  • Use a small suction cup and plastic tools for separating the Rear panel.

  • There is Adhesive tape on the edges of the phone and some between the Battery and the Back Cover, as well. I found a small tab to pull just inside the top of the cover that removed the adhesive and released the back panel from the battery. Its that same style adhesive strip as used in the Iphone 5/5c/5s.

Voeg opmerking toe

Before installing the new cover, you must clean the phone from the old adhesive tape and install a new one (if your spare part has come without double sided adhesive tape). Please SUBSCRIBE to my channel  ツ
  • Before installing the new cover, you must clean the phone from the old adhesive tape and install a new one (if your spare part has come without double sided adhesive tape).

  • Please SUBSCRIBE to my channel ツ

Should include the information about the NFC antenna.

Sounds like a dealbreaker for some people.

Diogo Pinheiro - Antwoord

What about it?

Makos - Antwoord

Disconnect the Battery Flex Cable and remove the two Philips screws. Li-Polymer Battery, 3.8V, 3200mAh Part number: LIS1543ERPC

Did you use the custom adhesive or the 3M double sided tape?

kelvinteohbc - Antwoord

Conclusie

To reassemble your device, follow these instructions in reverse order.

30 andere personen hebben deze handleiding voltooid.

ZFix

Lid sinds: 09-12-13

150.220 reputatie

424 handleidingen geschreven

Team

Master Techs Lid van Master Techs

Community

274 Leden

713 handleidingen geschreven

I've followed these instructions and sadly this has now left my phone not booting up with both the old battery (which was working fine previously) and the brand new replacement OEM battery. :( All it does is flash the red LED when I attempt to turn it on and I've left it to charge overnight and it remains to treat both batteries continually as if they're always empty. :( Anyone get any advice on this issue, or is this just a risk of replacing a Sony Xperia Z2 battery? :(

Jonathan D - Antwoord

Hey mate, did you fixed it meanwhile ? What it was ? I have the same issue. Thank you.

Laszlo Demeter -

Will it maintain its waterproofness?

Munyaradzi Murapa - Antwoord

Flashing red light could mean that your battery is not being detected. It is possible that you did not sit the battery connector properly. Hopefully the connector was not damaged when reinstalled. It is small and can be a little fiddly. I had to remove the battery when changing out the screen. After replacing everything, the same thing happened. I figured out the problem when the phone went from empty to full each time I pressed top third of the back cover plate.

kelvinteohbc - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 22

Afgelopen 7 Dagen: 176

Afgelopen 30 Dagen: 853

Altijd: 31,358