Inleiding

To complete this guide, you will need a screw driver and a prying device. Caution is advised when prying the back panel because permanent damage may occur if done incorrectly.

Onderdelen

Geen onderdelen nodig.

Unscrew two 5 mm Phillips #00 screws using a Phillips #00 screwdriver located on the bottom of the back of the device.
  • Unscrew two 5 mm Phillips #00 screws using a Phillips #00 screwdriver located on the bottom of the back of the device.

Voeg opmerking toe

Using a plastic opening tool, loosen the bottom portion of device.
  • Using a plastic opening tool, loosen the bottom portion of device.

Voeg opmerking toe

Using a plastic opening tool, loosen the top panel of the device.
  • Using a plastic opening tool, loosen the top panel of the device.

Voeg opmerking toe

Remove two 3 mm Philips #00 screws using a Phillips #00 screwdriver located on the portion under the top panel of the device.
  • Remove two 3 mm Philips #00 screws using a Phillips #00 screwdriver located on the portion under the top panel of the device.

Voeg opmerking toe

Remove back plate from device. Remove back plate from device. Remove back plate from device.
  • Remove back plate from device.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

lamallery

Lid sinds: 16-01-15

213 reputatie

1 Handleiding geschreven

Team

USF Tampa, Team 17-6, Watkins Winter 2015 Lid van USF Tampa, Team 17-6, Watkins Winter 2015

USFT-WATKINS-W15S17G6

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 3

Afgelopen 30 Dagen: 11

Altijd: 490