Ga door naar hoofdinhoud

Inleiding

A guide on how to replace the glass on a Sony Xperia Play.

  1. Remove the 6 silver torx screws marked in red
    • Remove the 6 silver torx screws marked in red

  2. Remove the 7 black torx screws marked in yellow.
    • Remove the 7 black torx screws marked in yellow.

  3. Using a plastic prying tool, go around the outside of the phone releasing the plastic clips.
    • Using a plastic prying tool, go around the outside of the phone releasing the plastic clips.

  4. Remove the plastic housing revealing the motherboard
    • Remove the plastic housing revealing the motherboard

    • Remove the two Phillips screws.

  5. PC Laptop batterijen

    Een snelle fix voor een grote boost.

    Nu winkelen

    PC Laptop batterijen

    Een snelle fix voor een grote boost.

    Nu winkelen
  6. Remove the headphone jack by carefully moving the dark plastic clip on the connector to 90 degrees
    • Remove the headphone jack by carefully moving the dark plastic clip on the connector to 90 degrees

  7. Slide the phone to the open position
    • Slide the phone to the open position

  8. Remove the display connector  marked in orange using a plastic spudger to pry it upwards
    • Remove the display connector marked in orange using a plastic spudger to pry it upwards

    • Remove the connector for the front buttons by prising the retaining clip to 90 degrees

  9. Remove motherboard
    • Remove motherboard

  10. Remove the buttons from the phone
    • Remove the buttons from the phone

  11. Remove the three Phillips screws.
    • Remove the three Phillips screws.

  12. Slide the metal frame across revealing the last screw . Make sure to keep the plastic cover after removing the screw
    • Slide the metal frame across revealing the last screw . Make sure to keep the plastic cover after removing the screw

    • Disconnect the digitizer cable

  13. Insert a plastic spudger around the edge of the frame and take the lcd assembely from the glass
    • Insert a plastic spudger around the edge of the frame and take the lcd assembely from the glass

    • Using a heat gun heat around the edges of the glass to soften the glue, and use your prying tool between the glass and the frame to take the glass off.

Conclusie

To reassemble your device, follow these instructions in reverse order.

16 andere personen hebben deze handleiding voltooid.

Kris James

Lid sinds: 27-01-12

594 Reputatie

1 Handleiding geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 4

Afgelopen 30 Dagen: 24

Altijd: 30,338