Inleiding

This guide will assist you in removing the microphone from your Sony Ericsson T68i.

Onderdelen

Geen onderdelen nodig.

  1. Remove the battery from the back.
    • Remove the battery from the back.

    Voeg opmerking toe

  2. Pry off the plastic cover from the top with a thin plastic shim, then remove it from the two bottom clips.
    • Pry off the plastic cover from the top with a thin plastic shim, then remove it from the two bottom clips.

    • Do not bend it too far down, or else you risk breaking the two bottom clips.

    Voeg opmerking toe

    • Unscrew all four Torx T6 screws.

    • Keep in a safe place.

    Voeg opmerking toe

  3. Gratis verzending op bestellingen van meer dan $20
    Gebruik code BLUEANDBLACK bij het afrekenen
    Gratis verzending op bestellingen van meer dan $20
    Gebruik code BLUEANDBLACK
    • After removing the screws, the two halves will separate. If not, then pry them gently apart.

    Voeg opmerking toe

    • Next remove the circuit board and screen from the device.

    • Use your T6 to remove the 4 screws holding the cover on.

    Voeg opmerking toe

    • The board and screen should just pop out at this point.

    Voeg opmerking toe

    • The microphone at the bottom of the rear housing can be levered out using a small screwdriver or any similar tool.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Tim Dascomb

Lid sinds: 13-04-10

123 Reputatie

7 handleidingen geschreven

Team

Cal Poly, Team 26-34, Regan Spring 2010 Lid van Cal Poly, Team 26-34, Regan Spring 2010

CPSU-REGAN-S10S26G34

4 Leden

13 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 2

Altijd: 2,015