Inleiding

Replace lens.

Remove Memory Stick Pro from the card reader slot on the bottom of the camera.
  • Remove Memory Stick Pro from the card reader slot on the bottom of the camera.

  • Remove both batteries.

Voeg opmerking toe

Remove the single visible screw from both sides of the camera.
  • Remove the single visible screw from both sides of the camera.

  • Remove the two screws that are adjacent to the warning label, which is on the underside of the camera.

  • Do NOT remove all four screws from the bottom.

Voeg opmerking toe

  • Gently remove the back cover from the camera.

  • The first time the case is removed, it will be stiff. Be patient and gently rock the cover back and forth until it slides free.

Voeg opmerking toe

  • Remove the two screws holding the circuit board down.

Voeg opmerking toe

  • Detach the orange cable from the board.

  • Use a thin object, like a paperclip, to gently pry the cable off the connector.

Voeg opmerking toe

  • The LCD screen sits in two slots; one on the bottom, and one on the left edge.

  • Slide LCD screen from the two slots.

  • Do not attempt to completely remove the screen, as it is still attached to the camera.

Voeg opmerking toe

  • To remove the LCD screen, detach the orange cable from the board.

  • If needed, replace the LCD screen.

Voeg opmerking toe

  • Remove the two screws holding down the steel back plate.

  • Remove steel back plate.

Voeg opmerking toe

  • Now remove the plastic plate that covers the motherboard.

Below and to the left of the viewfinder there is a vertical slot in the motherboard with a soldered connection to the flash capacitor on each side. Using a small screwdriver with an INSULATED handle, short these together for several seconds to discharge the potentially dangerous charge.

Philip Le Riche - Antwoord

  • Warning: Electric Shock From this point on, hold the camera by the chrome edges ONLY. Capacitors store electric charge even if the batteries are removed.

  • Remove the blue cable.

Voeg opmerking toe

  • Disconnect the flash cable (black and white wires) before completely removing the front case.

  • Gently start to remove the case.

  • Once the cable is free, set aside the front case.

If the front doesn't seem to want to come away, maybe the flash cable is caught around its socket.

Philip Le Riche - Antwoord

  • The speaker should now be clearly seen on the underside of the camera.

  • Gently unplug the speaker from the motherboard.

  • Replace the speaker.

Voeg opmerking toe

  • Remove the orange cable connecting the battery terminal to the motherboard.

Voeg opmerking toe

  • The battery terminal is now free from the board and can be slid out.

Voeg opmerking toe

  • Detach two cables that go from the motherboard to the lens.

  • Remove lens.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

6 andere personen hebben deze handleiding voltooid.

Thomas

Lid sinds: 14-04-10

109 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 15-50, Garner Spring 2010 Lid van Cal Poly, Team 15-50, Garner Spring 2010

CPSU-GARNER-S10S15G50

5 Leden

6 handleidingen geschreven

Één commentaar

Ifixit it's so awesome... For a guy who loves to bring things apart but is scared of how to do it ifixit is wonderful

ogunkayodesamuel - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 3

Afgelopen 7 Dagen: 25

Afgelopen 30 Dagen: 76

Altijd: 18,576