Onderdelen

Geen onderdelen nodig.

  1. Slide the battery latch down the side of the camera with your hands.
    • Slide the battery latch down the side of the camera with your hands.

    • The latch will automatically pop open.

    Voeg opmerking toe

  2. Unlatch the clip over the battery.
    • Unlatch the clip over the battery.

    • The battery will partially pop out.

    Voeg opmerking toe

    • Remove the battery from the camera.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Unscrew the four 3.0mm Phillips #000 screws holding the back case onto the camera; there are two screws on top and two on the bottom.

    Voeg opmerking toe

    • Pull the back case gently away from the rest of the camera.

    Voeg opmerking toe

    • Remove the two 3.0mm Phillips #000 screws holding the display to the metal backing.

    Voeg opmerking toe

    • Unlatch the display by sliding it towards the circuit board.

    Voeg opmerking toe

    • Remove the two ribbon cables attached to the circuit board by gently pulling them out of their slots.

    • Be careful not to rip the ribbon cables while disconnecting them.

    Voeg opmerking toe

    • The LCD is now separated from the camera.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Jenna Crawford

Lid sinds: 09-04-12

29 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 17-25, Amido Spring 2012 Lid van Cal Poly, Team 17-25, Amido Spring 2012

CPSU-AMIDO-S12S17G25

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 1

Altijd: 732