Onderdelen

Geen onderdelen nodig.

Remove two screws from the thumb dial panel on the back of the device
  • Remove two screws from the thumb dial panel on the back of the device

Voeg opmerking toe

Remove 1 screw from upper right corner on the back of the device.
  • Remove 1 screw from upper right corner on the back of the device.

Voeg opmerking toe

Romove 1 screw from thumb dial panel on the righ side of the device.
  • Romove 1 screw from thumb dial panel on the righ side of the device.

Voeg opmerking toe

Remove screw from lower right side of the device.
  • Remove screw from lower right side of the device.

Voeg opmerking toe

Remove 1 screw from the lower left side of the device.
  • Remove 1 screw from the lower left side of the device.

Voeg opmerking toe

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Romove 2 screws from the bottom of the device.
  • Romove 2 screws from the bottom of the device.

Voeg opmerking toe

Remove the thumb dial panel by sliding it away from the device.  (note: you can do this step earlier after you remove all screws from thumb drive panel)
  • Remove the thumb dial panel by sliding it away from the device. (note: you can do this step earlier after you remove all screws from thumb drive panel)

Voeg opmerking toe

Remove the back panel exposing the inside of the device.
  • Remove the back panel exposing the inside of the device.

Voeg opmerking toe

Remove 1 screw located on board below battery.
  • Remove 1 screw located on board below battery.

Voeg opmerking toe

Unplug male battery plug on the battery wire from the female battery plug on the board.
  • Unplug male battery plug on the battery wire from the female battery plug on the board.

Voeg opmerking toe

remove the battery from the device by sliding it out of the side of the device
  • remove the battery from the device by sliding it out of the side of the device

Voeg opmerking toe

slide new battery under the board from the side of the device.
  • slide new battery under the board from the side of the device.

Voeg opmerking toe

Plug battery back into board.
  • Plug battery back into board.

Voeg opmerking toe

Place screw back into board.
  • Place screw back into board.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Rob

Lid sinds: 04-10-11

1 Reputatie

2 handleidingen geschreven

Team

UW Stout, Team 5-6, Zhou Fall 2011 Lid van UW Stout, Team 5-6, Zhou Fall 2011

UWSTOUT-ZHOU-F11S5G6

4 Leden

2 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 4

Altijd: 1,440