Ga door naar hoofdinhoud
  1. Deze stap is niet vertaald. Help het te vertalen

    With a 13mm wrench, remove the axle nut located in the center of the wheel.
    • With a 13mm wrench, remove the axle nut located in the center of the wheel.

    • Set the axle nut aside, and remove the wheel.

    I am having stick like nut

    Srijan Suryansh - Antwoord

  2. Deze stap is niet vertaald. Help het te vertalen

    Position the wheel at the end of the axle.
    • Position the wheel at the end of the axle.

    • To remove the bearings, gently pry the wheel at a downward angle.

    • Perform this prying process on both sides of the wheel.

    • A bearing spacer should fall out once the bearings are removed.

  3. Deze stap is niet vertaald. Help het te vertalen

    Position the new wheel on a flat surface.
    • Position the new wheel on a flat surface.

    • Press the bearing into the hole of the new wheel.

    • Press firmly until the bearing snaps into place. The bearing's outside edges should be flush with the inside bottom edge of the wheel.

  4. Deze stap is niet vertaald. Help het te vertalen

    Flip the wheel over.
    • Flip the wheel over.

    • Insert the bearing spacer into the back the wheel.

  5. Deze stap is niet vertaald. Help het te vertalen

    Repeat the method from Step 3 to insert a bearing into the backside of the wheel.
    • Repeat the method from Step 3 to insert a bearing into the backside of the wheel.

    • With the bearings in place, the wheel can be placed on the axle.

  6. Deze stap is niet vertaald. Help het te vertalen

    Slide one washer onto the axle.
    • Slide one washer onto the axle.

  7. Deze stap is niet vertaald. Help het te vertalen

    Slide the wheel onto the axle.
    • Slide the wheel onto the axle.

    • The axle should go through both bearings and the bearing spacer.

  8. Deze stap is niet vertaald. Help het te vertalen

    Slide the second washer onto the axle on the outside of the wheel.
    • Slide the second washer onto the axle on the outside of the wheel.

  9. Deze stap is niet vertaald. Help het te vertalen

    Tighten the axle nut firmly.
    • Tighten the axle nut firmly.

    • Do not over tighten. The wheel should spin freely.

    • Repeat steps 1-9 for the remaining wheels.

Eindstreep

9 andere personen hebben deze handleiding voltooid.

Jared Stine

Lid sinds: 05-10-12

792 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 6-32, Regan Fall 2012 Lid van Cal Poly, Team 6-32, Regan Fall 2012

CPSU-REGAN-F12S6G32

5 Leden

6 handleidingen geschreven

3 Opmerkingen

Very helpful - just got a skateboard for my son and used this guide to adjust two wheels.

emvxl - Antwoord

thanks- i needed to upgrade my enjoi wheels to ricta clouds. thanks

Kenzie Peck - Antwoord

Great and awesome post. It is very helpful. This blog shows the importance of blog commenting. Thanks https://skatingkits.com/best-skateboard-...

Kelly Brien - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 3

Afgelopen 7 dagen: 22

Afgelopen 30 dagen: 132

Altijd: 76,088