Ga door naar hoofdinhoud

Onderdelen

Geen onderdelen opgegeven.

  1. Pop out the two small wheels located on the front end of the bottom of the roller brush compartment.
    • Pop out the two small wheels located on the front end of the bottom of the roller brush compartment.

  2. Remove the 10 Phillips screws located on the bottom of the roller brush compartment. (Two of these screws are located under the wheels from the previous step.) The screws have varying lengths, so keep track of where each one goes for reassembly.
    • Remove the 10 Phillips screws located on the bottom of the roller brush compartment. (Two of these screws are located under the wheels from the previous step.)

    • The screws have varying lengths, so keep track of where each one goes for reassembly.

  3. Laptop batterijen

    Batterijen voor alle grote PC-merken, met onze kwaliteitsgarantie.

    Nu winkelen

    Laptop batterijen

    Batterijen voor alle grote PC-merken, met onze kwaliteitsgarantie.

    Nu winkelen
  4. Remove the white plastic cover to expose the roller compartment underneath.
    • Remove the white plastic cover to expose the roller compartment underneath.

  5. Once the vacuum top is opened, you can simply remove the motor as shown in the image.
    • Once the vacuum top is opened, you can simply remove the motor as shown in the image.

    • Make sure to untangle or unhook any wires that are connected to the motor.

    • Once this is done, you can replace the old motor with a new one.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Molina Oung

Lid sinds: 27-03-15

205 Reputatie

1 Handleiding geschreven

Team

UMass Dartmouth, Team 5-4, Kish Spring 2015 Lid van UMass Dartmouth, Team 5-4, Kish Spring 2015

UMASSD-KISH-S15S5G4

4 Leden

10 handleidingen geschreven

Hi Where could I get a replacement motor from for NV501 model shark rotator .Or have the same motor rebuilt...Any help would be appreciated thank you.....

jacob - Antwoord

The screws on the bottom of roller brush compartment ARE NOT phillips head!!!!!!!!!!!!!!!!!!!!

randy - Antwoord

The screws are Phillips on mine. It may be a case of availability. If the manufacturer found a better deal on a different style of screw, they may have changed it.

Joe Evans -

The 10 screws on the roller brush compartment cover are NOT Phillips head!!!

randy - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 16

Afgelopen 30 Dagen: 105

Altijd: 8,627