Repareer je spullen Gemeenschap Winkel

Shark Navigator Motherboard Replacement

Wat je nodig hebt

  1. Shark Navigator Motherboard Replacement, Roller Brush Compartment: stap 1, afbeelding 1 van 1

    • Pop out the two small wheels located on the front end of the bottom of the roller brush compartment.

    Vertaal

  2. Shark Navigator Motherboard Replacement: stap 2, afbeelding 1 van 2 Shark Navigator Motherboard Replacement: stap 2, afbeelding 2 van 2

    • Remove the 10 Phillips screws located on the bottom of the roller brush compartment. (Two of these screws are located under the wheels from the previous step.)

    • The screws have varying lengths, so keep track of where each one goes for reassembly.

    Vertaal

  4. Shark Navigator Motherboard Replacement: stap 3, afbeelding 1 van 1

    • Remove the white plastic cover to expose the roller compartment underneath.

    Vertaal

  5. Shark Navigator Motherboard Replacement, Motherboard: stap 4, afbeelding 1 van 1

    • There is one screw at the edge of the circuit board. Unscrew the circuit board before attempting to take it out.

    Vertaal

  6. Shark Navigator Motherboard Replacement: stap 5, afbeelding 1 van 1

    • Take out the circuit board and replace with a new one. It may be better to allow a professional to re-wire the circuit board to the vacuum.

    Vertaal
Conclusie

To reassemble your device, follow these instructions in reverse order.

3 andere personen hebben deze handleiding voltooid.

Auteur

met 3 andere bijdragers

Mara

Lid sinds: 03/27/15

469 Reputatie

2 handleidingen geschreven

Medailles: 9

+6 andere badges

Team

UMass Dartmouth, Team 5-4, Kish Spring 2015 Lid van UMass Dartmouth, Team 5-4, Kish Spring 2015

UMASSD-KISH-S15S5G4

4 Leden

16 handleidingen geschreven

8 opmerkingen

Hi ..well done with the instructions.However I do have a Shark rotator vacuum NV501 .Unfortunately the motor on the brush is not working ,so I assume the motor is burnt.My request where could I find a replacement of the motor.I have searched a lot sites online but could not find a place to rebuild nor stock the same motor.Any help would be appreciated.Thank you.....To forward any information please do so on my email jacob.brown at hotmail.com thank you....

jacob - Antwoord

I couldn't figure out how to remove the bottom plate, your guide helped by informing me the last two screws are located under the little wheels. Thank you!

dylananon - Antwoord

When I had mine apart, two black rectangle magnet fell out, I can't figure out where the came from.

mardit - Antwoord

I had the same problem with the magnets - where do they go>

bjolivares1055 -

Also having problem locating both mother board and brush roller motor. Where can i purchase them?

Liz - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 5

Afgelopen 7 dagen: 18

Afgelopen 30 dagen: 40

Altijd: 7,717