Inleiding

We all know that the Sega Genesis brought to us many hours of fun, but, as we get older, the reset button gets older too.

Today, let's lend a hand to our nice friend and replace its reset button!

Onderdelen

Geen onderdelen nodig.

Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
  • Remove the six screws from the underside of the console with a Phillips #1 screwdriver.

Voeg opmerking toe

Flip the Sega Genesis upright.
  • Flip the Sega Genesis upright.

Voeg opmerking toe

  • Gently lift the top casing.

  • Note: the case will be connected to the main board by LED wires.

Voeg opmerking toe

  • Bend out the LED leads into vertical positions.

Voeg opmerking toe

  • Slide the LED wire apparatus off the lead pins.

  • Note: observe which color wire corresponds with which length of pin.

Voeg opmerking toe

  • Separate the main board from the outer case.

Voeg opmerking toe

  • Using Philips screwdriver, remove 11 screws securing silver casing.

Voeg opmerking toe

  • Remove silver case.

Voeg opmerking toe

  • Locate reset button on motherboard

Voeg opmerking toe

  • Place three pieces of 1cm x 1cm masking tape over reset button.

You could also, if you feel confident in your skills, desolder the old button and replace it with a standard 4-pin pushbutton. Resolder the new one, and it should work.

Tsaku - Antwoord

Conclusie

To reassemble your device, follow these instructions in reverse order. And the most important, be happy!

Één andere persoon heeft deze handleiding voltooid.

calvin

Lid sinds: 05-10-10

186 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team 3-29, Regan Fall 2010 Lid van Cal Poly, Team 3-29, Regan Fall 2010

CPSU-REGAN-F10S3G29

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 3

Afgelopen 7 Dagen: 23

Afgelopen 30 Dagen: 74

Altijd: 11,168