Skip to main content

Inleiding

This repair guide wil give a walk through on how to replace the power LED in a Sega Genesis.

Onderdelen

Geen onderdelen opgegeven.

  1. Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
    • Remove the six screws from the underside of the console with a Phillips #1 screwdriver.

  2. Flip the Sega Genesis upright.
    • Flip the Sega Genesis upright.

  3. Gently lift the top casing.
    • Gently lift the top casing.

    • Note: the case will be connected to the main board by LED wires.

  4. Bend out the LED leads into vertical positions.
    • Bend out the LED leads into vertical positions.

  5. MacBook-reparatiesets voor batterijen

    Vanaf $69.99

    Buy Now

    MacBook-reparatiesets voor batterijen

    Vanaf $69.99

    Buy Now
  6. Slide the LED wire apparatus off the lead pins.
    • Slide the LED wire apparatus off the lead pins.

    • Note: observe which color wire corresponds with which length of pin.

  7. Separate the main board from the outer case.
    • Separate the main board from the outer case.

  8. Remove plastic "Power / On" cover by pushing tabs together.
    • Remove plastic "Power / On" cover by pushing tabs together.

  9. Pull "Power / On" cover away from the console cover.
    • Pull "Power / On" cover away from the console cover.

  10. From the outside of the top cover, remove LED.
    • From the outside of the top cover, remove LED.

  11. Insert new LED (Click here to buy LED.)
  12. Re-insert "Power / On" cover until it clicks into place.
    • Re-insert "Power / On" cover until it clicks into place.

Conclusie

To reassemble your device, follow these instructions in reverse order.

5 andere personen hebben deze handleiding voltooid.

Anthony Porchia

Lid sinds: 11-10-10

341 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team 3-29, Regan Fall 2010 Lid van Cal Poly, Team 3-29, Regan Fall 2010

CPSU-REGAN-F10S3G29

4 Leden

5 handleidingen geschreven

My LED won't turn on when I turn on the machine though when I took it out and touched it on a battery it lit up. Did I put it back in wrong or what?

Brandon - Antwoord

Long leg on the LED goes to the red wire.

Short leg to the white wire. If that's not the case, you may have burned the LED or the spot doesn't work anymore.

Last attempt would be getting your +V5 from the resistor below as shown in this image.

http://i.imgur.com/TucGEXj.jpg

Thunder....16

PIero Bogani -

The model I am trying to change the led on is the 1601 HD graphics Genesis. The problem I have is there are NO simple easy press tabs to pop off the red ring. What is the correct way to remove the LED on this model? Thank you for your time.

snoopydaturd - Antwoord

Hey snoopy don't give up hope I made a video on how to fix your problem check out this video

https://youtu.be/HJPyhfy56a0

thebigtoe_98 -

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 19

Afgelopen 30 Dagen: 98

Altijd: 11,925