Repareer je spullen Gemeenschap Winkel

Sega Game Gear Headphone Jack/Volume Wheel Replacement

Inleiding

Guide to replace the small logic board that contains the 3.5mm headphone jack as well as the volume wheel.

Wat je nodig hebt

  1. Sega Game Gear Headphone Jack/Volume Wheel Replacement, Battery: stap 1, afbeelding 1 van 1

    • Place your device upside down and locate the two battery compartments.

    Vertaal

  2. Sega Game Gear Headphone Jack/Volume Wheel Replacement: stap 2, afbeelding 1 van 1

    • Press on the tabs at the bottom of the battery covers then lift up to remove.

    • Remove batteries if they are present.

    Vertaal

  3. Sega Game Gear Headphone Jack/Volume Wheel Replacement, Case: stap 3, afbeelding 1 van 1

    • Remove the following screws:

    • Six Phillips screws

    • One 4.5 mm Gamebit screw

    Vertaal

  5. Sega Game Gear Headphone Jack/Volume Wheel Replacement: stap 4, afbeelding 1 van 1

    • Use tweezers to take all other screws out.

    Vertaal

  6. Sega Game Gear Headphone Jack/Volume Wheel Replacement: stap 5, afbeelding 1 van 2 Sega Game Gear Headphone Jack/Volume Wheel Replacement: stap 5, afbeelding 2 van 2

    • Gently open the case by unfolding it over the top of the Sega Game Gear.

    • Do not pull the back of the case away, as cables are connected between both sides.

    Vertaal

  7. Sega Game Gear Headphone Jack/Volume Wheel Replacement: stap 6, afbeelding 1 van 3 Sega Game Gear Headphone Jack/Volume Wheel Replacement: stap 6, afbeelding 2 van 3 Sega Game Gear Headphone Jack/Volume Wheel Replacement: stap 6, afbeelding 3 van 3

    • Carefully unplug the 2 white-tipped connectors on the top cover.

    Vertaal

  8. Sega Game Gear Headphone Jack/Volume Wheel Replacement, Headphone Jack/Volume Wheel: stap 7, afbeelding 1 van 2 Sega Game Gear Headphone Jack/Volume Wheel Replacement, Headphone Jack/Volume Wheel: stap 7, afbeelding 2 van 2

    • Unscrew the screws to remove the metal covering.

    Vertaal

  9. Sega Game Gear Headphone Jack/Volume Wheel Replacement: stap 8, afbeelding 1 van 1

    • The screws that need to be removed are missing from this picture.

    • Remove the two screws from the highlighted locations.

    Vertaal
Conclusie

To reassemble your device, follow these instructions in reverse order.

Auteur

met 6 andere bijdragers

Brandon Page

Lid sinds: 04/15/10

182 Reputatie

2 handleidingen geschreven

Medailles: 10

+7 andere badges

Team

Cal Poly, Team 28-33, Regan Spring 2010 Lid van Cal Poly, Team 28-33, Regan Spring 2010

CPSU-REGAN-S10S28G33

5 Leden

13 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 4

Afgelopen 30 dagen: 19

Altijd: 7,094