Onderdelen

Geen onderdelen nodig.

Using a Phillips head screwdriver remove  six screws from the bottom of the console. The six screws are marked.
  • Using a Phillips head screwdriver remove six screws from the bottom of the console.

    • The six screws are marked.

Voeg opmerking toe

Remove the two screws that attach the Genesis' connector to the rest of the console.
  • Remove the two screws that attach the Genesis' connector to the rest of the console.

    • The two screws are marked in the diagram.

Voeg opmerking toe

Slide the lock tab to the left to separate the halves of the console.
  • Slide the lock tab to the left to separate the halves of the console.

Voeg opmerking toe

Lift from the left side to remove the top of the case.
  • Lift from the left side to remove the top of the case.

Voeg opmerking toe

Using the spudger, pry the cover off of the Genesis attachment.
  • Using the spudger, pry the cover off of the Genesis attachment.

Voeg opmerking toe

Lift the top of the case to remove the cover.
  • Lift the top of the case to remove the cover.

Voeg opmerking toe

Remove the faceplate by pulling it up, then out.
  • Remove the faceplate by pulling it up, then out.

Voeg opmerking toe

Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate. The three screws are shown on the diagram.
  • Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate.

    • The three screws are shown on the diagram.

Voeg opmerking toe

Remove the two screws from the plastic bar. The two screws are shown pictured.
  • Remove the two screws from the plastic bar.

    • The two screws are shown pictured.

Voeg opmerking toe

To remove the CD tray Remove the four screws with the Phillips head screwdriver.
  • To remove the CD tray

    • Remove the four screws with the Phillips head screwdriver.

Voeg opmerking toe

Carefully unplug the wire connected to optical reader.
  • Carefully unplug the wire connected to optical reader.

Voeg opmerking toe

Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver. The four screws are highlighted on the diagram.
  • Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver.

    • The four screws are highlighted on the diagram.

  • The four springs below the circuit board are attached to the screws, so be careful not to lose them when you remove the screws.

Voeg opmerking toe

Carefully remove the CD tray from circuit board.
  • Carefully remove the CD tray from circuit board.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

sskyllin

Lid sinds: 18-10-10

21 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 5-14, Maness Fall 2010 Lid van Cal Poly, Team 5-14, Maness Fall 2010

CPSU-MANESS-F10S5G14

5 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 5

Afgelopen 30 Dagen: 27

Altijd: 6,675