Onderdelen

Geen onderdelen nodig.

Place the monitor face down.
  • Place the monitor face down.

  • Remove the four 11.5mm screws with a #2 Phillips screwdriver.

  • Remove the stand by pulling it out.

Voeg opmerking toe

Remove two 11.5mm screws with a  #2 Phillips screwdriver.
  • Remove two 11.5mm screws with a #2 Phillips screwdriver.

  • Remove the plastic bar.

Voeg opmerking toe

Using a  #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.
  • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

Voeg opmerking toe

Pry the monitor using the plastic opening tool to release the clips holding the cover on. There are four clips on each side, four on the top, and one on the bottom. You may hear a loud snapping noise when releasing the clips.  Do not be alarmed, it is natural.
  • Pry the monitor using the plastic opening tool to release the clips holding the cover on.

    • There are four clips on each side, four on the top, and one on the bottom.

    • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

  • Once all the clips have been released, remove the cover by pulling it up.

Voeg opmerking toe

Using the  #2 Phillips screwdriver, remove the one 6mm screw. Unplug the indicated cable by pulling on the base.
  • Using the #2 Phillips screwdriver, remove the one 6mm screw.

  • Unplug the indicated cable by pulling on the base.

  • Slide the cover toward the top of the monitor.

  • Remove the cover.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Ted Hsueh

Lid sinds: 20-09-12

170 reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 16-56, Forte Fall 2012 Lid van Cal Poly, Team 16-56, Forte Fall 2012

CPSU-FORTE-F12S16G56

5 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 310