Inleiding

This guide shows how to replace the LCD screen on the Samsung L100.

Remove the six external screws from the camera using a Phillips #0 screwdriver.
  • Remove the six external screws from the camera using a Phillips #0 screwdriver.

  • After the screws has been removed, the bottom of the back half of the external case should be loosened from the camera.

  • Be careful, make sure you don't lose the screws.

Voeg opmerking toe

Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery.
  • Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery.

Voeg opmerking toe

  • Slide your fingernail or a plastic spudger in the groove from the bottom to the top right side of the camera.

Voeg opmerking toe

  • Carefully squeeze the top right corner of the camera and pry off the external cover.

  • If you hear a "cracking" sound. This is normal.

  • Continue to pull the external cover and it will come off cleanly.

  • Be cautious of the flash capacitor. It carries an electrical charge, that may give you an unpleasant shock.

Voeg opmerking toe

  • Carefully pull off the back cover, parts behind the back of the case might fall out.

Voeg opmerking toe

  • Remove the screws holding the circuit board.

  • Carefully remove the circuit board.

Voeg opmerking toe

  • Carefully lift circuit board from camera.

  • Circuit board still attached to camera by ribbon.

Voeg opmerking toe

  • Remove the front cover. It should come off easily.

  • Buttons might fall out when you remove the front cover.

Voeg opmerking toe

  • Remove the green tape that holds the LCD screen.

  • Carefully lift the LCD Screen.

Voeg opmerking toe

  • Flip the camera over to the other side.

  • Lift the black strip and the ribbon should easily come out.

  • The LCD Screen should be completely separated from the camera now.

Voeg opmerking toe

  • Insert the new LCD Screen by pushing the ribbon into the slot.

  • Flip the black strip back down to lock the ribbon in.

  • Your new LCD Screen should be connected to the camera now.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Hasit

Lid sinds: 15-04-10

183 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 6-17, Maness Spring 2010 Lid van Cal Poly, Team 6-17, Maness Spring 2010

CPSU-MANESS-S10S6G17

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 3

Altijd: 5,703