Inleiding

This guide is a step-by-step guide on how to replace a Samsung Juke logic board.

  1. Locate the button on the bottom of the phone. Once located, press and hold the button down.
    • Locate the button on the bottom of the phone. Once located, press and hold the button down.

    Voeg opmerking toe

  2. While holding the button down, remove the back cover of the phone.
    • While holding the button down, remove the back cover of the phone.

    Voeg opmerking toe

    • Use the size 00 Phillips screwdriver to remove the four screws located on the back of the phone. These screws are circled in yellow in the given image.

    Voeg opmerking toe

    • Using the same 00 Phillips screwdriver, remove the two screws at the bottom back plate of the phone near the camera and the speaker.

    • These screws will be 7.25 mm long.

    Voeg opmerking toe

    • Before proceeding, locate the USB port (where the charger can be plugged in) and open it using the iFixit Opening Tool.

    • Failure to open USB port cover at this stage may result in damaging the device.

    Voeg opmerking toe

    • Remove the screws on either side of the camera/speaker with a Phillips 00 screwdriver.

    • These screws will be 5.45 mm long.

    Voeg opmerking toe

    • Use the iFixit Opening Tool to begin removing the camera/speaker from the logic board.

    • Practice caution to prevent damage to the attaching ribbon.

    Voeg opmerking toe

    • To completely remove the camera/speaker, locate the orange attachment beneath it (as shown in the image).

    • Then, use the iFixit Opening Tool to gently pry the camera/speaker off.

    Voeg opmerking toe

    • Use the iFixit Opening Tool to pop off the yellow tab on the logic board.

    Voeg opmerking toe

    • Use the iFixit Opening Tool to pop off the other orange tab to free the logic board.

    Voeg opmerking toe

    • To completely remove the logic board, use the iFixit Opening Tool to pop it up, then use your fingers to pull it out.

    • Do not be alarmed if the volume and hold switch buttons are removed from the logic board.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Renee Kuzniar

Lid sinds: 13-04-10

82 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 6-18, Maness Spring 2010 Lid van Cal Poly, Team 6-18, Maness Spring 2010

CPSU-MANESS-S10S6G18

3 Leden

12 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 2

Afgelopen 30 Dagen: 2

Altijd: 2,691