Ga door naar hoofdinhoud

Samsung Galaxy S6 Motherboard Assembly Replacement

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. Samsung Galaxy S6 Motherboard Assembly Replacement, Motherboard Assembly: stap 1, afbeelding 1 van 3 Samsung Galaxy S6 Motherboard Assembly Replacement, Motherboard Assembly: stap 1, afbeelding 2 van 3 Samsung Galaxy S6 Motherboard Assembly Replacement, Motherboard Assembly: stap 1, afbeelding 3 van 3
    • Use the pointed edge of a spudger to disconnect the Bluetooth and Wi-Fi antenna cable connectors from their sockets on the motherboard.

  2. Samsung Galaxy S6 Motherboard Assembly Replacement: stap 2, afbeelding 1 van 2 Samsung Galaxy S6 Motherboard Assembly Replacement: stap 2, afbeelding 2 van 2
    • Use the flat end of the spudger to disconnect the home button connector.

  3. Samsung Galaxy S6 Motherboard Assembly Replacement: stap 3, afbeelding 1 van 2 Samsung Galaxy S6 Motherboard Assembly Replacement: stap 3, afbeelding 2 van 2
    • Use the flat end of a spudger to disconnect the display assembly cable from the motherboard.

  4. Samsung Galaxy S6 Motherboard Assembly Replacement: stap 4, afbeelding 1 van 2 Samsung Galaxy S6 Motherboard Assembly Replacement: stap 4, afbeelding 2 van 2
    • Disconnect the earpiece speaker assembly cable connector from the motherboard.

  5. Samsung Galaxy S6 Motherboard Assembly Replacement: stap 5, afbeelding 1 van 2 Samsung Galaxy S6 Motherboard Assembly Replacement: stap 5, afbeelding 2 van 2
    • Lift the camera-side end of the motherboard to separate it from the display frame.

    • You may need to move some of the ribbon cables out of the way while you lift the motherboard. If the board is hard to lift, check that it is fully disconnected and not caught on any ribbon cables.

    • Do not fully remove the motherboard yet—it is still attached to the daughterboard via a ribbon cable on the underside of the motherboard.

  6. Samsung Galaxy S6 Motherboard Assembly Replacement: stap 6, afbeelding 1 van 2 Samsung Galaxy S6 Motherboard Assembly Replacement: stap 6, afbeelding 2 van 2
    • Use the flat end of a spudger to disconnect the daughterboard ribbon cable connector from its socket on the underside of the motherboard.

Conclusie

To reassemble your device, follow these instructions in reverse order. When reinstalling the rear glass, refer to the rear glass adhesive replacement guide.

3 andere personen hebben deze handleiding voltooid.

Evan Noronha

Lid sinds: 02/05/15

223.241 Reputatie

168 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 881