Ga door naar hoofdinhoud

Samsung Captivate Antenna Cable Replacement

Wat je nodig hebt

  1. Samsung Captivate Antenna Cable Replacement, Battery: stap 1, afbeelding 1 van 1
    • Remove the back cover by pressing on the bottom section of the phone and sliding the bottom piece downward.

    • Lift up the back cover.

  2. Samsung Captivate Antenna Cable Replacement: stap 2, afbeelding 1 van 1
    • Place your finger on the bottom of the battery and lift to remove.

  3. Samsung Captivate Antenna Cable Replacement: stap 3, afbeelding 1 van 1
    • Replace the old battery with the new one.

  4. Samsung Captivate Antenna Cable Replacement, Rear Case: stap 4, afbeelding 1 van 1
    • Insert the spudger underneath the bottom section of the phone.

    • Gently lift and push the spudger to slide the bottom section down to reveal two hidden screws.

  5. Samsung Captivate Antenna Cable Replacement: stap 5, afbeelding 1 van 1
    • Remove the six 4.5mm #000 Phillips screws.

  6. Samsung Captivate Antenna Cable Replacement: stap 6, afbeelding 1 van 3 Samsung Captivate Antenna Cable Replacement: stap 6, afbeelding 2 van 3 Samsung Captivate Antenna Cable Replacement: stap 6, afbeelding 3 van 3
    • Starting at a bottom corner, use the spudger to separate the rear case from the front display.

    • Move the spudger towards the top on both sides. The plastic opening tool is easier to use for this step.

    • Be careful when detaching the top. Free each side, stopping short of the center of the cover. Apply backward pressure on both corners with a finger applying pressure on the center, and slide the whole back cover toward the bottom of the device. Note: forcing the cover can result in cracked plastic.

  7. Samsung Captivate Antenna Cable Replacement: stap 7, afbeelding 1 van 1
    • Separate the rear case from the phone.

  8. Samsung Captivate Antenna Cable Replacement, Antenna Cable: stap 8, afbeelding 1 van 2 Samsung Captivate Antenna Cable Replacement, Antenna Cable: stap 8, afbeelding 2 van 2
    • Use a spudger tool to pry up the antenna cable from the connector on the motherboard.

    • Pry up the other end of the cable from the connector on the antenna array.

Conclusie

To reassemble your device, follow these instructions in reverse order.

7 andere personen hebben deze handleiding voltooid.

Drew Bentz

Lid sinds: 09/22/11

565 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 20-25, Maness Fall 2011 Lid van Cal Poly, Team 20-25, Maness Fall 2011

CPSU-MANESS-F11S20G25

3 Leden

9 handleidingen geschreven

2 opmerkingen

Quick question, is this the antenna for wifi or cellular network?

Michael Perdomo - Antwoord

This is actually just the cable that connects the motherboard to the antenna array. I believe the antenna array that it connects to is for WiFi though.

Drew Bentz -

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 4

Altijd: 3,597