Ga door naar hoofdinhoud

Samsung 27E510C NAV Button Replacement

Wat je nodig hebt

  1. Samsung 27E510C  NAV Button Replacement, Back Panel: stap 1, afbeelding 1 van 3 Samsung 27E510C  NAV Button Replacement, Back Panel: stap 1, afbeelding 2 van 3 Samsung 27E510C  NAV Button Replacement, Back Panel: stap 1, afbeelding 3 van 3
    • Use the #1 Phillips head screw driver to remove each 13.75mm length screw from the rear panel.

    • The screw alone with the ports is a different size than the rest, its length is 12mm.

  2. Samsung 27E510C  NAV Button Replacement: stap 2, afbeelding 1 van 2 Samsung 27E510C  NAV Button Replacement: stap 2, afbeelding 2 van 2
    • Insert the heavy duty spudger in between the monitors back panel and its frame.

    • Use the heavy duty spudger to pry open the back panel.

    • Over aggressive prying could break the tabs holding the back panel in place.

  3. Samsung 27E510C  NAV Button Replacement, Rear navigation button: stap 3, afbeelding 1 van 1
    • Carefully remove the tape holding down the connector wire.

    • You will need to re-attach the tape upon reassembly.

  4. Samsung 27E510C  NAV Button Replacement: stap 4, afbeelding 1 van 1
    • Disconnect the navigation button from the motherboard by holding down the thumb tab and pulling its connector out.

  5. Samsung 27E510C  NAV Button Replacement: stap 5, afbeelding 1 van 2 Samsung 27E510C  NAV Button Replacement: stap 5, afbeelding 2 van 2
    • Remove the navigation buttons connector wire from the monitors body tab.

  6. Samsung 27E510C  NAV Button Replacement: stap 6, afbeelding 1 van 1
    • With one thumb, hold down the tab on the bottom of the navigation buttons base.

    • While holding the tab down, lift the base of the navigation button with your other hand.

  7. Samsung 27E510C  NAV Button Replacement: stap 7, afbeelding 1 van 3 Samsung 27E510C  NAV Button Replacement: stap 7, afbeelding 2 van 3 Samsung 27E510C  NAV Button Replacement: stap 7, afbeelding 3 van 3
    • Remove the connector wire from the defective navigation button by first gripping its connectors thumb tab.

    • While gripping the thumb tab, pull the connector from the base of the navigation button.

    • You can save the connector wire since it may not be defective.

Conclusie

To reassemble your device, follow these instructions in reverse order.

giggythore

Lid sinds: 10/14/17

366 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team S9-G1, Banghart Fall 2017 Lid van Cal Poly, Team S9-G1, Banghart Fall 2017

CPSU-BANGHART-F17S9G1

6 Leden

14 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 2

Afgelopen 30 dagen: 19

Altijd: 471